Kozy Heat Fireplaces KZK-045 Manuel page 12

3.2.2 Combustible Wall Finish
• Figure 3.5 shows installation of combustible wall finish up to 1"
thick. This combustible material goes on any required non-
combustible materials as shown in Figure 3.1 on page 10.
• This 1" (25mm) combustible material is able to go down to the
fireplace finishing edge.
• See Figure 3.3 on page 11 for up to 1" (25mm) thick
combustible material installation around the discharge trim of
the KZK air discharge opening.
Non-combustible zone
Combustible wall nisihng
up to 1" (25mm) thick
may be installed up to
the top nishing edge
and the bottom of the
air discharge opening
Non-combustible
material
Figure 3.5, #KZK-045 Combustible Wall Finish
12 FACING AND FINISHING
Finishing edge
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces Komfort Zone Kit #KZK-045 R.1