Publicité
Les langues disponibles
Les langues disponibles
28 04 13 / 03.17 / VA
Packing list:
1 13-conductor cable set
1 Socket 13-pin
1 4-P socket
1 Trailer module
1.
Disconnect the earth lead from the battery
2.
Remove the back shelf and the floor covering of the boot. Take out the rear closure cover and the boot side cover
by the rear lights so that the lights are easily reachable (remove foam material).
3.
In order to draw electric bunch to connection socket, drill a hole of 6 mm diameter in boot floor (possibly on left side
of lock handle). Increase the diameter to 38 mm. Secure edge with anti-corrosion agent.
4.
Connect the cable set in the following way:
a)
Draw 13-connector end of cable set with installed socket through the hole referred to in point four from
boot outside and then through the hole in socket base.Fasten cable bush located on cable bunch in the
holeinside the vehicle.
b)
There are two different washers under the socket. One is used by side entrance of leads, the other - in axis
entrance.
Side entrance: used in permanent assembly of tow hook with closed socket holder and detached tow
hook with folded socket holder. In such event, remove overpass in casing of connection socket.
Note !!! Use washer under socket assigned to side entrance for folded socket holder. Remove the other
washer assigned for axis entrance (it will not be used).
Axis entrance: used in permanent assembly of tow hook with opened socket holder and detached tow
hook without folded socket holder.
Remove washer assigned for side entrance (it will not be used).
c)
Socket is connected according to the following scheme:
Picture1
Function
Indicator left
Trailer fog light
Earth
Indicator right
Tail light right
Stop light
Tail light left
Reversing light
Trailer current supply
Charge line plus
Charge line earth
Not assigned
Earth (trailer)
5.
Push the socket with rubber retaining plate and screw the socket tightly onto the retaining plate using the supplied
nuts and screws:
a)
Pay special attention to the right position of rubber retaining plate,
b)
Put the cable set gently to avoid any folds and to secure it from possible wiping.
Electrical Set for Trailer Connection
13-pin
Peugeot 307 hatchback manufactured 01.01 -
Part no.:
28 04 13
8 Cable ties 140 mm
5 Cable ties 100 mm
1 Screws M5X10
1 Sheet-metal screw
Installation instruction
Contact description
Cable colour
1
black/white
2
grey
3
brown
4
black/green
5
grey/red
6
black/red
7
grey/black
8
blue/red
9
red/blue 2,5mm
10
yellow 2,5mm
11
white/brown 2,5mm
12
13
white/brown 2,5mm
3 Screws M5X15
4 Nuts M5
4 Spring washer
2
2
2
2
8
9
7
1
10
6
2
4
3
5
11
12
13
Contact description in
13-pin socket
Publicité
