bosal 033-741 Instructions De Montage page 19

The fact that the towing bracket has been mounted to the vehicle must be entered in the
vehicle papers at the next possible opportunity. The mounting instructions must be added to
the vehicle papers.
General Installation Intructions:
If present, remove insulating compound and/or underseal in the area of the towing bracket
contact surfaces. Coat bare bodywork with anti-corrosion paint.
Mount 7-pin electrical system as per DINV 72570.
Mount 13-pin electrical system as per ISO 11446.
Retighten all mounting bolts of the towing bracket after aprox. 1000 towing km. Please note,
that after mounting the drawbar the mass of your vehicle will change.
Mounting instructions:
Remove the bumper then lower the exhauster and the spare wheel.
–
Loosely fix the side plates (2,3) to the drag hook body (1) at positions „a".
–
Loosely fix the drag hook to the internal side of the rear wall at positions „c".
–
Loosely fix the side plates (2,3) to the chassis beam at positions „d".
–
Loosely fix the side plates (2,3) to the drag hook body at positions „b".
–
Adjust the drag hook into mid-position and tighten the bolts.
–
According to requirements carry out connecting of electric wires breaking the rear sheaf of
–
cables.
Cut off the bumper with the attached templet.
–
Reinstall the bumper, the spare wheel and the exhauster.
–
Only specialised services are authorised to install drawhooks.
–
19