Publicité
Les langues disponibles
Les langues disponibles
44 28 02 07/13 / 06.09 /VA
Packing list: 1 Cable set
1 Socket
1 Socket retaining plate
1.
Disconnect the earth lead from the battery
2.
Remove inside screens of boot near tail lights of vehicle.
3.
In order to draw electric bunch to connection socket, drill a hole of 6 mm diameter in boot floor (possibly on left side
of lock handle). Increase the diameter to 20mm. Secure edge with anti-corrosion agent.
4.
Connect bunch to socket in the following way:
a) Draw end of cable bunch with metal connections of cables through the place referred to in point 3 from boot
outside and through a hole near socket connection handle, fasten supplied grommet in the drilled hole,
b) Draw attached rubber socket retaining plate over the end of cable set (if necessary use anti-friction agent),
c) Disassemble the socket and connect cables according to the following assignment:
7 pin
Function
Indicator left
Fog light
Earth
Indicator right
Tail light right
Stop light
Tail light left
Fog light
13 pin
Function
Indicator left
Trailer fog light
Rear fog light
Earth
Indicator right
Tail light right
Stop light
Tail light left
Reversing light
Trailer current supply
Charge line plus
Charge line earth
Not assigned
Earth (trailer)
5.
Push the socket with rubber retaining plate and screw the socket tightly onto the retaining plate using the supplied
nuts and screws:
a) Pay special attention to the right position of rubber retaining plate,
b) Put the cable set gently to avoid any folds and to secure it from possible wiping.
Electrical Set for Trailer Connection
7-pin
13-pin
Peugeot 306 Break manufactured 04.97-
3 Screws M5X35
3 Nuts M5
3 Spring washer
Installation instruction
Contact description
Cable colour
1
(L)
black/white
grey
2
(54-G)
3
(31)
brown
4
(R)
black/green
5
(58-R)
grey/red
6
(54)
black/red
7
(58-L)
grey/black
8
(58-b)
grey/white
Contact description
Cable colour
1
black/white
grey
2
2a
grey/white
3
brown
4
black/green
5
grey/red
6
black/red
7
grey/black
8
blue/red
9
red/blue 2,5mm
10
yellow 2,5mm
white/brown 2,5mm
11
12
13
white/brown
Part no. 010-518
Part no. 013-468
1 Rubber grommet
2 Heat shrinkable tube
8 Cable ties
2
2
2
2
2,5mm
3 Quick connector (1x reserve)
1 Sheet-metal screw (only for 13-pin)
1
2
6
7
3
5
4
8
Contact description in
7-pin socket
8
9
7
1
10
6
2
4
3
5
11
12
13
2a
Contact description in
13-pin socket
Publicité
