Publicité
Ssang Yong Kyron
09/2005 - ....
Ref. 1547
Fitting instructions
1)
Disassemble the bumper and permanently remove the metal buffer beam. Remove thespare wheel.
2)
Insert, through the liberated opening (see photo 1 and 3) in the rear of the chassis beam, filling pieces (2)
in the chassis till above the provided drillings. Place the tow bar with points (A) against the underside of
the chassis beams on the provided drillings, insert the bolts and the washers and place the plate (1) on
top. Screw everything firmly on (see tension).
3)
Make the incision in the bumper according to drawing (1) and the incision in the buffer beam according
to drawing (2) and photo 2.
4)
Fix the wiring for the parking controll on the tube of the tow bar with the adhesive sockles and carrier
straps.
5)
Assemble the plastic buffer beam on the provided points on the tow bar and replace the bumper on the
vehicle.
6)
Assemble the ball together with the socket holder and the security shackle, insert the bolts and tighten
everything firmly.
Disassemblage of the bumper
- remove the rear-light units by removing 2x2 small screws and the units
- 2x1 small screw under the light units
- 2 small bolts under the bumper in the metal buffer beam, 2 small screws under on a level with the wheel cases
- 2x5 small screws in th wheel cases
- 4 plastic nails + 2 small screws at the entrance of the trunk
Composition
Tow bar reference 1547
1 ball T48K005
4 bolts M12x65 - DIN931
4 security nuts M12 - DIN985
1 piece left T48 (800025)
1 piece right T48 (800026)
2 tubes T48 (800011)
1 security shackle (800000)
1 socket holder P04
4 bolts DIN931 - M12x120
4 nuts DIN934 - M12
All bolts and nuts : quality 8.8
Note
Please consult your cardealer or owners manual for the maximal permissable towing mass.
Remove any bitumen coating on the fastening position for the tow bar.
When drilling, be carefull not to damage any brake lines, electrical wiring or fuel lines.
(*-*')
4 washers 40x35x12x4mm
(*-*')
4 security washers DIN128A - M12
(*-*')
2 bolts DIN933 - M8x25
(*-*')
2 nuts DIN934 - M8
(*-*')
2 security washers DIN128A - M8
(*-*')
2 washers 25x8.4x2mm
(*')
5 adhesive sockels for carrier straps
(*)
5 straps 190mm
(A)
2 plates (1)
(A)
2 tubecompositions (2)
(A)
(A)
(B)
(B)
(B)
(B)
(B)
(B)
Publicité
