Search For Errors - VINCENT SA-32 Manuel D'utilisation

Symptom
Unit does not work
after pressing the
power button
No sound on both
channels although
the unit is ready for
use

SEARCH FOR ERRORS

Possible Cause
Mains cable is not connected to a suitable
mains wall outlet.
Mains cable has not been firmly inserted into
wall power socket and the device's socket.
Otherwise it may be defective.
Unit fuse or unit is defective.
The currently selected audio source (8) is
giving no signal.
One of the audio settings of a connected
DVD player (analogue/digital) has not been
correctly selected.
The output of the source device is not connec-
ted or is wrongly connected e.g. not connec-
ted to the selected input channel terminal of
the preamplifier.
Wrong input channel has been selected at the
preamplifier.
Volume (VOLUME) is set too low at the pre-
amplifier.
Main amplifier(s) has/have not been connec-
ted correctly to the preamplifier, is/are swit-
ched off or is/are faulty.
The speaker cables are not properly connec-
ted to the main amplifier's terminals or are
defective.
Countermeasure
Connect to a functioning socket using a suit-
able mains voltage.
Check the power cable. If necessary,
exchange it with a suitable mains cable and
push its plug firmly into wall socket and the
device's power connector.
Contact your dealer.
Switch on the source unit and begin play-
back.
Correct the settings in the player's setup.
Correct the connection.
Set the amplifier to the input that your desired
source is connected to (8).
Carefully increase the volume (6).
Check the connection and ready status of the
main amplifier(s) and whether it is/they are
working.
Check and tighten the speaker cables at the
main amplifier and the speakers.
Vincent
37