Operating The Appliance - VINCENT SA-32 Manuel D'utilisation

STANDBY CONTROL (POWER CONTROL)
The SA-32 is equipped with two output connectors for the power control. Here, the switching signal gene-
rated by the SA-32 is available for other components of the system. Two HiFi components that are able
to react to the power control signal can be connected directly to the amplifier's power control outputs. If
more than two devices, which can be controlled, are to be connected, then it is necessary to make the
power control connection between the amplifier and these further devices through the outputs of the two
devices which are connected directly. For that reason, every HiFi component that accepts power control
signals is also equipped with a power control output. Thus, in theory it is possible to provide an infinite
number of HiFi components with the power control signal. This approach, to loop a signal through a chain
of components, is commonly referred to as "daisy chaining".
SA-32
Attention:
Many devices which can be controlled by a switching signal (not preamplifiers or integrated ampli-
fiers), have two terminals which do not differentiate between input and output. In this case either of
the two can be selected.
"POWER CONTROL" sockets of preamplifiers or integrated amplifiers must not be interconnected! All
receiving devices must not be connected to more than one preamplifier or integrated amplifier (directly
or indirectly)!
Operation
Switch on and off
Select an input
Vincent
34
CONNECTIONS FOR THE
S3 S4
S2 S5
S1 S6
power control cable

OPERATING THE APPLIANCE

Button(s) Description
The preamplifier is switched on and off using this button at the front panel. It
has no standby option. When switched off the device is internally separated
POWER (4)
from the AC power. As a precaution, after switching on, the volume setting
of the preamplifier should be reduced.
If you turn the dial "INPUT", you select one of the devices connected to the
INPUT (8)
inputs on the back of the SA-31 (9) for playback. Before switching over the
input channel, the volume (6) should be turned down as a precaution!
main amplifier
e.g. SP-T700
second main amplifier
e.g. second SP-T700