VINCENT SA-32 Manuel D'utilisation page 31

CONNECTION OF A RECORDING DEVICE
If you want, you can use the RCA sockets "REC OUT" (10) on the back of the appliance to connect an
analogue stereo recording device (e.g. CD recorder, cassette recorder etc.) or another appliance that is
intended for receiving the unchanged, fixed stereo output level (line level) from the signal source selected
on the amplifier at any given time. The output level is independent from the volume and tone settings
(BASS, TREBLE, TONE, LOUD).
SA-32
Connect this signal output to the signal input ("LINE IN", "TAPE IN" or "REC IN") on the recording appli-
ance using RCA cables. Please note that some recording equipment can have a slightly detrimental effect
on the audio signal quality. Some recording devices have rather low input impedance, which can slightly
alter the input signal voltage. For maximal music enjoyment we recommend that you connect to the "REC"
terminal only for as long as the recording is actually being made.
CONNECTION OF ONE OR MORE POWER AMPLIFIERS
This preamplifier has two stereo preamplifier outputs with RCA connectors and one stereo preamplifier
output with XLR connectors for the main amplifier channels. In this way it is possible to drive six loudspea-
kers or bi-wire/bi-amp one pair of loudspeakers. The main amplifiers supply the system's loudspeakers
and the loudspeakers are connected to the outputs of these. Instead of each stereo main amplifier shown
here you can alternatively use two mono main amplifiers.
To connect one pair of loudspeakers you will need two main amplifier channels, for example one stereo
main amplifier. You can alternatively connect the amplifier(s) using RCA or XLR connection cables. In the
case of RCA, connect both sockets named "1" in the field "OUTPUT" (12) with the RCA input sockets of
the main amplifier channels (often marked as "INPUT" or "POWER AMP IN"). For this you need RCA
cables. In the case of XLR connection choose the output labelled "3". Please pay attention not to interchan-
ge right with left channels. The letters "R" and "L" indicate the correct correlation. You may further use the
SA-32 preamplifier output marked with "2" for a headphone amplifier.
SA-32
RCA connection
S3 S4
S2 S5
S1 S6
S3 S4
S2 S5
S1 S6
RCA connection
INPUT
e.g. Tape recorder
Stereo main amplifier
Vincent
31