bosal 010-598 Instructions De Montage page 4

6. Draw end of bunch with black/green cable to right standing lights:
a) There is a empty contact of right indicator on lamp bracket. Connect black/green cable to this contact.
7.
Draw remaining part of bunch to the left side of boot:
a) There is a 14-input joint of light control module below left standing lights. Disconnect 14-input plug and connect
it with suitable joint in electric bunch. Connect remaining joint in electric bunch to empty joint in light control
module,
b) Draw end of bunch with black/white, grey/white and additionally blue/red cables in 13-polar set to left standing lights.
There are empty contacts on lamp bracket. Connect black/white cable to empty contact of left indicator. Connect
blue/red cable to empty contact of reversing lights. Connect grey/white cable to empty contact of fog lights,
c) Cut purple/white cable of fog lights in an easily accessible place. In 850 Lim. and S70 types, it is located
behind left side screen of boot, near spare wheel well. In 850 estate car and V70 types, it is located in conduit
with cables on the left side of boot. Put a jacket shrinking under high temperature on each cut cable end in such
a way, that the end is located in the middle of the jacket's length and then heat the jacket on the cable using
either a singeing machine or a lighter. Clip quick joints at the end of cable running from fog light switch. Connect
grey cable of connection bunch to quick joints,
d) Connect brown cable (additionally white/brown cable in 13-polar set) to earth below left standing lights in 850
estate car/ V70 types. In 850 Lim./ S70 types, connect it near rear vehicle metal sheet (for example drill a 3 mm,
connect and fix it the eyelet terminal with sheet metal screw; do not secure the hole with anti-corrosion agent).
8.
Trailer power supply:
Only for 13-polar version. 3-input housing (red/blue, yellow and white/brown leads) is provided for expanded
socket functions. Put this part of lead bunch behind the trim. To expand socket functions it is necessary to order the
following parts:
Function "current supply and earth"
Function "current supply, charge line and earth"
Fix all the leads with supplied band clips, assemble previously disassembled parts.
Connect accumulator and check all vehicle functions with connected trailer or other suitable testing device.
Control lamp flashes if a contact breaker of indicator (3x21W) or emergency lights is switched on (6x21W) with
connected trailer.
Additional control lamp of trailer installation is used in vehicle.
Information:
part no. 014-169
part no. 015-069