Hisense H299BME Notice D'utilisation page 10

Leveling
The appliance should be level in order to
eliminate vibration. we recommend that you
level the appliance by the following steps.
1.Roll the refrigerator into place.
2.turn the adjustable feet (with your fingers
or a suitable screw driver) until it touches
the floor.
3.Tilt back the top backwards for about 10-
15mm or 0.5°by turn the feet. This will allow
the doors to self-close providing a consistent
closed seal.
4.Whenever you want to move the
appliance, remember to turn the feet back
up so that the appliance can roll freely.
Reinstall the appliance when relocating.
Electrical connection
Caution! Any electrical work required to
install this appliance should be carried out by
a qualified or authorized
Warning!
This appliance must be grounded.
The manufacturer declines any liability should
these safety measures not be observed.
Installing the rubber supporting
It is only applicable to H360BMI-WD
s crew provided in a plastic bag with your
appliance, you can install these accessories
according to the following procedure.
5°
personnel.
Hisense Refrigerator
Note:
There is no need to install these accessories
under normal usage. Only under the extreme
circumstances, cabinet empty while load on
door with total mass of 16 kg and opening the
door about 90 degree , this
take risk of tipping. Then rubber supporting
pad should be fastened to the lower base
cover to steady this appliance.
1. Tilt appliance to find screw hole on the
left of lower base cover.
lo wer base cover
2. Put screw into the hole of rubber
supporting pad.
scr ew
rubber supporting pad
3.Make screw in alignment with the hole on
lower base cover . Fasten rubber
supporting pad to the base cover firmly by
a cross screw driver (self-provided).
10
refrigerator may
cross screwdrawer