Reversing The Door - Hisense H299BME Notice D'utilisation

Reversing the door

The side at which the door opens can be
changed from the right side (as supplied) to
the left side, if the installation site requires.
Tools you will need:
1. 8mm socket driver
2. cross-shaped screwdriver
3. Putty knife or thin-blade screwdriver
Before you start lay the refrigerator on it's
back in order to gain access to the base,
you should rest it on soft foam packaging or
similar material to avoid damaging the
cooling pipes at the rear of the refrigerator.
To reverse the door, the following steps are
generally recommended.
1. Stand refrigerator upright. Open upper
door, take out all door shelves and water
storage box part (to avoid them damaged),
and then close door.
2. open the upper hinge cover which is at
the top right corner of the refrigerator.
3.Unscrew the special flange self-tapping
screws which are used for fixing the right
upper hinge part by a 8mm socket driver or
a spanner(please support the upper door
with your hand when doing it ).
4.Remove the rightt upper hinge part,
replace the left upper hinge part.
5.Remove upper door and place it on
smooth surface with panel upwards.
Detach door holder and stop block and
then install another door holder (in plastic
bag) and stop block to left.
Door racks
Hisense Refrigerator
upper hinge
cover (right)
special flange
selftapping screws
right upper hinge part
16