Cleaning And Care - Hisense H299BME Notice D'utilisation

Cleaning and care

Cleaning and care
For hygienic reasons, the appliance interior,
including interior accessories, should be
cleaned regularly.
The appliance should be cleaned and
maintained at least every two months.
Warning! Danger of electrical shock!
The appliance should not be connected to
the main power supply
Before cleaning, switch the appliance off
and remove the plug from the
supply, switch off, or
breaker or fuse.
Notice!
Remove the food from the appliance
before cleaning. Store them in a cool
place and keep well covered.
Never clean the appliance with a steam
cleaner. Moisture could accumulate in
electrical components.
Hot vapors can lead to the damage of
plastic parts.
Ethereal oils and organic solvents can
attack plastic parts, e.g. lemon juice or the
juice from an orange peel, butyric acid,or
cleansers that contain acetic acid. Do not
allow such substances to come into contact
with appliance parts.
Do not use any abrasive cleansers.
Clean the appliance and the interior
accessories with a cloth and lukewarm
water. Commercially available dish washing
detergents may also be used.
After cleaning, wipe with fresh water and a
clean dish cloth.
Accumulation of dust at the condenser
increases energy consumption; clean the
condenser at the back of the appliance
once a year with a soft brush or a vacuum
cleaner.(Only for the outside-condenser
product)
Check the water drain hole on the rear wall
of the refrigerator compartment.
Clear a blocked drain hole with the aid of
something like soft green peg, an be careful
not to create any damage to the cabinet by
sharp objects.
After everything is dry, the appliance back
into service.
during cleaning.
main power
shut off the circuit
Hisense Refrigerator
Taking the appliance out of service
Empty the appliance.
Pull out the power plug.
Clean thoroughly (see section: Cleaning
and Care).
Leave the door open to prevent odours.
Changing the LED light
Warning!
If the LED light bulb is
damaged, only a qualified electrician
of competent person must carry out
it!
Changing the LED light bulb carry out by
inexperienced persons may cause injury or
serious malfunctioning. it must be replaced
by a qualified persons in order to avoid a
hazard. Contact your local Service Force
Center for help.
Before changing the light bulb, switch
off the appliance and unplug it, or pull
the fuse or the circuit breaker.
LED light bulb data: 220-240 V.
To switch off the appliance, set the
temperature regulator to position "0".
Unplug the mains plug.
Press the bulb in the center with finger.
Take out the lampshade with "1" type
screwdriver, change the bulb, and then
replace the lampshade.
Put the refrigerator back into operation.
20