Hisense H299BME Notice D'utilisation page 17

17
① Door holder
② Stop block
③ Self-tapping screws
6. Loose screws used to fix middle hinge
and remove middle hinge. Then turn middle
hinge by 180. Take washer on axis and put
it on another end. Place it well for use.
7. Remove lower door and place panel
upwards on smooth surface. Turn door
holder by 180° and then install it to
corresponding position on left side together
stop block.
① Door holder
② Stop block
③ Self-tapping screws
①
②
③
8. Change screw hole covers on middle
cover plate from left to right (as shown in
figure below).
① Lower hinge part（right）
② Front foot fixed board
③ Adjustable bottom feet part
④ Self-tapping screws
9. Screw out lower
hinge, change it to
the near hole site,
and then screw up
and mount washer.
10. Change lower hinge part to left and front
foot fixed board to right and fix them with
screws. Then install adjustable bottom feet
parts.
Lower hinge part (left)
Hisense Refrigerator
washer
Note: washer may
stick to lower door.