gdw 1289 Instructions De Montage page 5

Subaru Impreza sedan+break
2001 - ......
Ref
Fitting instructions
1) Disassemble the bumper in the rear.
towing rings.
Disassemble the ventilation system and the fuel tank on the right side.
remove the lock rings which are in the rear of the the chassis beam as well left as
right.
2) Place the mounting pieces (k) and (l) in the chassis beams so that the points (A),
(A') and (G) of the mounting pieces are matching with the provided drillings in the
underside of the chassis beam.
against the underside of the chassis so that the points (A), (A') and (G) are
matching with those of the mounting pieces (k) and (l).
matching with the drillings in the chassis, ar the botom.
washers by (C) and (C').
tighten yet. Insert the bolts by the points (C) and (C') through the trunk.
rubbers which stop the holes must be removed (the square washer has to be placed
in the trunk too).
3) Place on the left side of the suspension of the exhaust by the points (G) and
re-assemble on the right side the ventilation system and the fuel tank on point (A).
Insert the bolts and the washers but do not tighten yet.
4) Place afterwards the tow bar between the mounting pieces (k) and (l) so that the
points (D) and (E) are matching.
(h). The points (F) of the mounting pieces (h) serve to re-attache the bumper.
Insert all bolts and nuts and tighten everything firmly.
5) Replace the bumper but remove at the botom, in the middle, the fixing support.
The fastening strip on the inside of the bumper must be removed too.
Composition
1 tow bar reference 1289
1 ball T45M004 or T36M000 escamotable
2 bolts M12 x 65
2 bolts M12 x 60
4 security nuts M12
2 mounting pieces T45
2 tubes T45
1 security shackle
10 bolts M12 x 35
12 security washers M12
2 nuts M12
2 bolts M12 x 1,25 x 35
2 washers 50 x 50 x 12 x 2
2 bolts M10 x 110
2 security washers M10
2 nuts M10
2 mounting pieces (g)
2 mounting pieces (h)
1 mounting piece (i)
1 mounting piece (k)
1 mounting piece (j)
1 mounting piece (l)
Note
----
Please consult your cardealer, or owners manual for the max. Permissible towing mass.
Remove any bitumen coating on the fastening position for the tow bar.
When drilling, be carefull not to damage any brake lines, electrical wiring or feul lines.
.1289
Disassemble the supension of the exhaust on the left side.
Place afterwards the mounting pieces (i) and (j)
Insert in point (B) the bolts M12 x 1,25 x 35 but do not
Afterwards, remove the screwed part of the two
Assemble by the points (E) the mounting pieces
(*)
(*)
(*)
(*)
(*)
(*)
(*)
(A,A',G,D,E)
(A,A',G,D,E,B)
(E)
(B)
(C-C')
(C-C')
(C-C')
(C-C')
(C-C')
(E-F)
(C-B-A-G)
(D-E-A-G)
(C'-B-A-A')
(D-E-A-A')
Further
(B), (C) and (C') are
Insert the heightened
GB
The