Publicité
Les langues disponibles
Les langues disponibles
5
Place the filter inside the gun grip again.
Note: Place the spring and filter in the correct position.
Apply grease to the tube thread. Assemble in gun.
6
Note: Before this, check that the grip locking seal (no. 17 -
figure 1) is in position.
Place the trigger guard in its original position.
7
ELIMINATING AN OBSTRUCTION
If the spray cap becomes blocked during operation, stop spraying
immediately. Place the gun safety lock. Then operate according to
the following procedure:
Engage the gun safety. Open the compression valve of the gun.
1
Remove the tip guard and nut.
2
Extract the spray tip.
3
Remove the obstruction by blowing with compressed air
4
through the front of the spray cap. Should this prove to be
insufficient, clean the spray tip with the right cleaning solvent
and use the right tip cleaning solvent.
Note: Do not use metal or sharp objects for cleaning the cap.
Engage the gun safety.
1
Turn the lever 180º (no. 1 - figure 8).
2
Disengage the gun safety, tighten the gun trigger inside the
3
grounded metal vessel pointing this towards the sides of the
vessel to remove the obstruction. Release the gun trigger.
Note: The metal vessel used to collect the product must be
correctly grounded.
Engage the safety once more. Turn the lever (no. 1 - figure 8)
4
again 180º to the spray position.
Maximum operating pressure
Dimensions
Weight
Maximum temperature
Product inlet
Product outlet
Parts in contact with the fluid
CLEANING THE GUN AND THE ACCESSORIES
Fixed tip
Swivel tip
TECHNICAL DATA
1
If the blockage persists, reengage the gun safety. Open the unit
5
decompression valve.
Loosen the nut which secures the tip. Remove the spray tip.
6
Remove the obstruction by blowing with compressed air
7
through the front of the spray tip. Should this prove to be
insufficient, clean the spray tip with the right cleaning solvent.
220 Bar
210 x 130 milimetres
516 grams
72 degrees
1/4" Gas BSP swivel
3.20 milimetres (diffuser head)
Stainless steel, Nylon, Aluminium,
Viton, Tungsten Carbide, Copper
12
FIGURE 8
Publicité
