Kozy Heat Fireplaces KOMFORT ZONE Mode D'emploi page 12

3.2.2 Combustible Wall Finish
• Figure 3.4 shows installation of combustible wall finish up to 1"
thick. This combustible material goes on any required non-
combustible materials as shown in Figure 3.1 on page 10.
• This 1" (25mm) combustible material is able to go down to the
fireplace finishing edge.
• See Figure 3.3 on page 11 for up to 1" (25mm) thick
combustible material installation around the KZK air discharge
grille.
Non-combustible zone
Combustible wall nish
up to 1" (25mm) thick
may be installed over
cement board
Finishing Edge
Figure 3.4, #KZK-1510A Combustible Wall Finish
12 FACING AND FINISHING
½
around pipe
Steel
Framing
Fireplace Enclosure Floor
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
" (13mm) clearance
Komfort Zone Kit #KZK-1510A R.1