Bissell POWERTRAK 1790 Serie Guide De L'utilisateur page 7

Maintenance: Empty Dirt Tank
1
Remove tank by pressing the release
button on the tank handle.
3
Empty contents
of dirt tank into
trash container,
and gently shake
the top handle to
remove build up.
NOTE: If you notice excess build up around the top of the tank, before removing
top piece, gently tap the tank to allow contents to settle.
Maintenance: Pre-Motor Filter
1
NOTE: Filter can be rinsed in warm water. Allow it to completely dry before
replacing. If the filter is damaged, replace the part.
WARNING
To reduce the risk of electrical shock, turn power switch off and disconnect polarized plug
from electrical outlet before performing maintenance or troubleshooting checks.
Remove the dirt
tank to locate and
remove the pre-
motor filter. Pinch
the filter and lift to
remove from unit.
2
4
Place the top handle
straight down into
the dirt tank. Align
the latch arrows and
gently twist clockwise.
When fully assembled,
the tank will click into
place. Replace the tank
back onto the vacuum
– it will click when fully
installed.
2
Grasp handle on
back of tank with
one hand and the
top handle with
the other. Twist
the top handle
counterclockwise
until latches release.
Pull the top handle
straight up from the
dirt tank.
While holding
over trash, gently
separate filter
layers (being
careful not to rip
filter layers) and
shake out excess
debris.
www.BISSELL.com
7