Infrared Remote Codes; Troubleshooting; Guarantee; Owner Information - Monitor Audio IA150-2 Manuel Du Propriétaire

Infrared Remote Codes

'Connect' models only.
'Connect' amplifiers have an IR input and output for
use with universal remote controls. The commands
for the amplifiers follow the standard NEC protocol
and can be downloaded from: monitoraudio.com

Troubleshooting

Fault LED Indicators:
White LED - channel is clipping/ in protection
mode
When the input signal is too high the channel LED's
will illuminate solid white. If this happens decrease
either the trim level on the amp or decrease the
volume of the audio source.
Flashing White LED - thermal protection
If this happens we would recommend switching off
the amplifier and leaving it to cool down to room
temperature before powering back On.
Other faults:
No Power
If there is no power to the amplifier check the fuse
inside the plug (if applicable) and the amps internal
fuse, refer to the Connections Overview on page 3.
No Sound
Ensure to check all connections and cables, if the
amp is a 'Connect' model ensure channels are
routed correctly and not muted.
If the amplifier is configured in bridge mode ensure
the switch/ settings and wiring are correctly
configured.
If it still does not output a signal or the fault mode
is still present, please contact your local dealer/
distributor or Monitor Audio immediately.
12

Guarantee

Both the craftsmanship and the performance of
this product is guaranteed against manufacturing
defects for the period of five years from the date
of purchase (see conditions in the Important Safety
Instructions booklet), provided that the product was
supplied by an authorised Monitor Audio retailer
under the consumer sale agreement.
To help us find your warranty details within our
customer database, should the need arise, please
take a few minutes to register your product(s) online
at: monitoraudio.com

Owner Information

Product Details
Model:
Product Serial No:
Date of Purchase:
Dealer Details
Dealer Name:
Address:
Post code:
E-mail address:
Installation Amplifiers