Input/ Output Settings - Monitor Audio IA150-2 Manuel Du Propriétaire

Power in
Power Mode
Standby
Power Button N/A
Audio 2W
Voltage Trigger 2W
Audio Green 0.5W
Voltage Green
0.5W
Save & Restore
Here all settings can be saved to a file, which can
then be used to restore the settings from if required.
Load Global Preset
Active Global Preset – Show current active Global
Preset (this displays the name of the currently active
global preset, this is not a text input box) – with
reset button to reset current active preset to default
settings.
Select Global Preset – Selects which preset you
wish to edit and implement from drop down menu.
The load button next to the drop down menu will
activate the selected preset and restart the amplifier
after confirmation from the pop-up prompt. The
active global preset will change when the web page
has been refreshed.
Edit Preset name – Text field to edit name of the
preset currently selected from drop down menu.
Import/ Export Global Preset
All Presets – Import/ Export all Global Presets to/
from a file.
Single Preset – Import/ Export a single global
preset from menu to/ from a file.
Duplicate Global Preset
Copy Global Preset 'X' to Global Preset 'Y'. Both of
which are selectable from the drop down menus.
Reset
Factory Reset – Reset button will reset all settings and
all presets (global & DSP) to original factory settings.
When pressed the power LED on the amplifier will
flash, followed by restarting.
Update
Firmware Update - This button will install firmware
(.bin file) chosen by the user. If the update is
successful a notification will appear in the web
portal. Follow the prompts to then restart the
amplifier and return to the 'Basic Setting' page. The
latest firmware will be available for download on our
website: monitoraudio.com
NOTE: We recommend checking your firmware
each installation. The latest firmware can be
found on our website: monitoraudio.com
Network Communication
in Standby
N/A
Yes
Yes
No
No
monitoraudio.com

Input/ Output Settings

Here you can configure the routing for each input to
a selected output. Individual trim level, mode, gain
offset and volume parameters can also be set. This
is also where you can activate amplifier modes such
as 70V line (IA800-2C only) or bridge.
NOTE: Some changes made in the web
portal will not be visible until the page
is manually refreshed or you navigate
to one of the other pages.
Input Setup
Here it shows all available input channels. Each
input name can be customised and the trim level
can be adjusted for each channel by +/ - 6dB. Trim
Level is the input level before being amplified.
Output Setup
Channel – Select an output channel to edit. When
a channel is selected from a drop down menu its
equivalent channels will also show on the other
drop down. (i.e. if 1 LEFT is selected on the left
hand drop down, 1 RIGHT will appear in the right
hand drop down).
Output Name – Text Input for channel output
name.
Stereo/ Mono – Stereo/ Mono selection for each
channel. With Mono selected L & R input channels
are summed to mono on selected outputs.
DSP Preset – Selects saved DSP Preset to apply
to output channel. This will always be individually
selectable on each channel, never linked between
stereo pairs.
9