OJ Electronics OJ-HMI Instructions page 3

OJ-HMI
volumes and filter pressures. The temperature shown to the right
of the house is the temperature setpoint. The icons shown in the
lower part of the screen can be changed and may therefore differ
from those shown in these instructions.
FAN SPEED
To set fan speed, press the fan in
the lower part of the home screen.
You can choose between five
predefined fan speeds. Off, Auto,
Low, High and Service Stop. If you
choose Auto, OJ-AIR2-HMI-35T
will follow a predefined program.
If you choose Low, the prede-
fined program is overridden and
the fan operates at low speed. If
you choose High, the predefined
program is overridden and the
fan operates at high speed. If you
choose Off, the fan comes to a
complete standstill until fan speed
is again changed. If you choose
Service Stop, the system shuts down and can only be restarted
locally from the control panel.
TEMPERATURE
To change the temperature
setpoint for the selected control
mode, press the temperature on
the panel's home screen. Change
the temperature using the arrows
and confirm with the green button.
4 © 2015 OJ Electronics A/S
English OJ-HMI
SETTINGS
OJ-AIR2-HMI-35T is used together with an OJ-Air2 Master, and all
communication is via the master. Some settings can be made via
the menu icon in the upper right corner of the home screen.
Begin by pressing the menu icon in the upper right corner of the
home screen.
The following screen is then
displayed:
Home
Press this icon to return to the home screen.
Communication
Here you can configure LAN set-
tings such as static/dynamic IP
and associated addresses.
© 2015 OJ Electronics A/S
English
5