Adler europe AD 7909 Mode D'emploi page 6

Remote controller – Picture E
A. Power button
C. Timer / Temperature down button
E. Sleep model
G. Timer button
CONTROL PANEL operation – picture D
Press button "A" to turn on and turn off the machine, the buzzer will play signal once. The control lamp "O" will switch on the control panel.
Press button "B" to switch mode, between cooling mode → fan mode → dehumidifying mode.
Press button "D/C" Up / Down to change the setting temperature or setting time, operate as follows:
-
While setting temperature, press button up or down button to select the required temperature (not available in fan or dehumidifying
mode).
-
While setting time, press up button or down button to select the required time.
Press button „F" to select the Fan speed:
-
In cooling and fan mode, press the button "F" to select high or low wind speed operation. In too cold conditions, it may not run according to the
set wind speed.
-
In dehumidifying mode, pressing the button "F" is invalid, and the fan will forcibly choose low wind speed operation.
Press button "E" to select the Sleep Mode:
- In the cooling mode, press both buttons "F" and "D" to turn on the sleep mode, then the unit will work on Energy - Saving and quiet type.
The sleep model control lamp "N" will switch on the control panel.
Press button "G" to select operation period, when the LCD screen flashes, press up button "D" or down button "C" to select the required
time range. Time setting range 1-24 hour and can be adjusted up or down by one hour.
Delay start function:
- Power ON delay setting:
Switch off the device and then press the button "G", next press up button "D" or down button "C" to select the required time value. The
maximum power on delay time is 24 hours. The device will be switched on after the delay time has elapsed.
- Power OFF delay setting:
Switch on the device and then press the button "G" , next press up button "D" or down button "C" to select the required time value. The
maximum power off delay time is 24 hours. The device will be switched off after the delay time has elapsed.
Flashing will stop soon and LED screen come back to show required temperature.
REMOTE CONTROLLER operation – picture E
The remote controller transmits signals to the system.
Button "A" - the appliance will be started when it is energized or will be stopped when it is in operation, if you press this button.
Button "B" - press it to select operation mode: cool mode → dry mode → fan mode.
Button "C" / "D" - press to adjust the room temperature and the timer.
Button "E" - press to set or cancel sleep mode.
Button "F" - press it to select fan speed in sequence: low / high wind speed.
Button "G" - press to set the operation time from 1 to 24 hours.
PROTECTION DEVICES
1. Frost Protection Function:
In cooling, dehumidifying or economic power saving mode, if the temperature of the exhaust pipe is too low, the machine will automatically
enter protection status; if the temperature of the exhaust pipe rises to a certain temperature, it can automatically revert to normal operation.
2. Overflow Protection Function "M":
When water in the water pan exceeds the warning level, the machine will automatically sound an alarm, and the "FULL" indicator light "M"
will flash. At this time, drain the water according to drainage instructions. After the water is emptied, the machine will automatically return to
the original state.
3. Protection Function of the Compressor
To increase the service life of the compressor, it has a 3-minute delay booting protection function after the compressor is turned off.
B. Mode button
D. Timer / Temperature up button
F. Fan speed button
6