Carat C8000 Mode D'emploi page 30

GB
ADJUSTING THE SLIDING CARRIAGE
The sliding carriage is fitted with an adjustment
scale.
When excess vertical carriage movement occurs,
proceed as follows:
1) With a 13 mm metric wrench and a 6 mm
hexagonal male wrench, loosen the lower wheel
supports (photo 19).
1 1 9 9
2) move the lower wheel support in the adjustment
slot until the vertical clearance is removed
(photo 20).
2 2 0 0
3) tighten the lower wheel support again.
CAUTION !
IN CASE OF LATERAL MOVEMENT ON THE
CARRIAGE, TIGHTEN
SUPPORTS FURTHER.
ALL THE WHEEL
10. Disposal
When scrapping either the entire machine or parts
of there, the materials used must be disposed of in
accordance with current laws.
Electric motor
Aluminium
Steel
Copper
Polyamide
Steel
Polyamide
Aluminium
Submersible pump
Polyamide
Steel
Aluminium
Copper
Epoxy Resin
30
Main casing
AL
AC
CU
PA
AC
PA
AL
PA
AC
AL
CU