Carat C8000 Mode D'emploi page 24

GB
"TRANSLATION OF THE ORIGINAL INSTRUCTIONS"
Technical Data
Power Supply:
Power Rating:
Type of operation allowed:
INTERMITTENT - SERVICE S6 40%
Rotation Speed:
Capacitor:
Amperometric circuit breaker:
Thermal circuit breaker:
IP level:
Working mass:
Tank capacity
(min/max)
CUTTING TOOL
DIAMOND TIPPED DISC
CONTINUOUS CROWN:
Ceramics, marble, grès, terracotta
LASER / SECTORS:
Concrete, natural stone, granite, abrasive materials
(With narrow eyelets, max. 5 mm).
TURBO:
Concrete, natural stone, granite, refractory material
THE TOOL / MATERIAL
COMBINATIONS ARE PURELY INDICATIVE.
ALWAYS APPLY
INSTRUCTIONS SUPPLIED BY THE TOOL
MANUFACTURER,
APPLICATION.
Max tool diameter:
Tool hole:
Max cutting depth:
90° cut:
45° cut:
Max cut length:
Water circulation pump:
Under working conditions, the machine has a
noise emission above 85 dB (A).
230V 50Hz~
2,2 Kw
40% operating under load
60% running freely
2800 min
40 µF
160°C
68 Kg
: 19 / 25 lit.
TO BE
THE OPERATING
BEFORE EACH
Ø350 mm
25,4 mm
110 mm
80 mm
800 mm
S2 230V 50Hz
The level of noise emitted by the machine was
measured in accordance with UN EN12418 and UN
EN3744 standards, in conformance with directive
98/37/EC.
LW - SOUND POWER LEVEL = 79.8/0.0 dB(A)
/mW(A)
LOP - SOUND PRESSURE LEVEL AT THE
OPERATING POSITION=68.5 dB(A)
LOP Max - PEAK SOUND PRESSURE LEVEL IN
THE OPERATING POSITIO N=80.7 dB(C
Measurements were taken with no load and at the
maximum speed using a turbo cutting tool with a
diameter of 350 mm. Art. 867.
-1
Under working conditions, the machine has a noise
emission above 85 dB (A).
13A
The hand-arm vibration level transmitted was
measured in accordance with the UN ISO 5349
standard during the cutting of poroton brick.
54
(L 280 x L 140 x H 100 mm) with a turbo cutting tool
with a diameter of 350mm. Art. 967
- Weighted acceleration value at = 1.15 m/s2
(measurement uncertainty of 0.28m/s2).
CUT
24