Carat C8000 Mode D'emploi page 26

GB
2 2
3 3
4. Fitting and removing the diamond-tipped disc
Slacken the three nuts on the disc guard and
remove the disc.
Remove the disc-locking nut using a 30 mm
spanner and a 5 mm Allen wrench.
4 4
CAUTION !
THE DISC LOCK NUT HAS A LEFT-HAND
THREAD.
• Proceed to fit the disc, checking the rotation
direction clearly marked on the tool.
• Tighten the disc and replace the disc guard.
ASSEMBLING THE Ø 300 mm DIAMOND DISC
For correct use of the machine with Ø 300 mm tools
it is necessary to adjust the cutting head stroke
scale.
Proceed as illustrated as follows:
- Assemble the Ø 300mm tool as indicated in
paragraph 4 (assembly and disassembly of the
diamond disc).
- Loosen the limit stop adjuster positioned close
to the cutting head locking lever (photo 5).
5 5
- Using the locking lever, fix the motor head so
that the diamond part of the tool is brought to
the inside of the working surface groove
(photo 6).
6 6
CAUTION !
DO NOT BRING THE CUTTING TOOL INTO
CONTACT WITH
WORKING SURFACE GROOVE.
- Bring the adjustment screw back to support the
frame pin and fix it with the two locking nuts
(Photo 7).
26
THE BOTTOM OF THE