Options - Electrolux GA55SLV220 Notice D'utilisation

58 www.electrolux.com

5. OPTIONS

Activate or deactivate the options
before the start of a programme.
You cannot activate or deactivate
the options while a programme
operates.
If one or more options are set,
make sure that the related indica-
tors are on before the programme
starts.
5.1 ExtraHygiene
This option gives better results for the hy-
giene. During the rinsing phase, the tem-
perature stays at 70 °C for 10 to 14 mi-
nutes.
Press the ExtraHygiene touchpad:
• If the option is applicable to the pro-
gramme, the related indicator comes
on.
• If the option is not applicable to the
programme, the related indicator flash-
es for some seconds and then stays
off.
5.2 ProBoost
This function increases the water pressure
by 40% and gives better washing results
when dishes are very dirty.
Press the ProBoost touchpad:
• If the option is applicable to the pro-
gramme, the related indicator comes
on.
• If the option is not applicable to the
programme, the related indicator flash-
es for some seconds and then stays
off.
5.3 Multitab
Activate this option only when you use the
combi detergent tablets.
This option deactivates the flow of rinse
aid and salt. The related indicators are off.
The programme duration can increase.
• Press the multitab touchpad, the rela-
ted indicator comes on.
• The option stays on until you deactivate
it. Press the multitab touchpad, the re-
lated indicator goes off.
All manuals and user guides at all-guides.com
If you stop to use the combi
detergent tablets, before you start to
use separately detergent, rinse aid
and dishwasher salt, do these steps:
1. Deactivate the multitab option.
2. Set the water softener to the highest
level.
3. Make sure that the salt container and
the rinse aid dispenser are full.
4. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.
5. Adjust the water softener to the water
hardness in your area.
6. Adjust the released quantity of rinse
aid.
5.4 Acoustic signals
The acoustic signals operate in these
conditions:
• The programme is completed.
• The level of the water softener is adjus-
ted electronically.
• The appliance has a malfunction.
Factory setting: on. You can de-
activate the acoustic signals.
Deactivating the acoustic signals
1. Press the on/off button to activate the
appliance. Make sure that the appli-
ance is in setting mode. Refer to 'SET-
TING AND STARTING A PRO-
GRAMME'.
2. Press and hold touchpads (4) and (5)
at the same time until the indicators of
touchpads (3), (4) and (5) flash.
3. Press touchpad (5),
• The indicators of touchpads (3) and
(4) go off.
• The indicator of touchpad (5) contin-
ues to flash.
• The display shows the setting of the
acoustic signals.
4. Press touchpad (5) to change the set-
ting.
On
Off