Putting Your Water Computer Out Of Operation; Maintenance - Gardena C 1030 plus Mode D'emploi

Reset :
Important information :

6. Putting Your Water Computer out of Operation

Storage /
Overwintering :
Disposal :
(in accordance with
RL 2002 / 96 / EC)
Disposing of flat batteries :

7. Maintenance

Clean filter :
H
M
G
10
The factory settings are restored.
v Press Menu-key and Man.-key simultaneously for 3 seconds.
All the LCD symbols are displayed for 2 seconds and the
display moves to the normal display.
• All the program data are set to zero.
• The manual watering period is set to
• The time and day of the week are retained.
If no entry is made during programming for a period of more than
60 seconds, the normal display reappears. In this case all changes
made up till now will be applied.
When a sensor installed in the water computer registers damp
(OFF), the programmed watering is not carried out.
1. To preserve the battery, it should be removed (see
4. Initial Operation).
The programmes remain stored. If the battery is inserted
again in spring, only the time of day and the weekday must
be newly entered.
2. Store controller and valve unit in a dry place where they are
protected from frost.
The product must not be added to normal household waste. It
must be disposed of in line with local environmental regulations.
v Important : Make sure that the unit is disposed of via your
municipal recycling collection centre.
v Please return flat batteries to a GARDENA dealer or dispose
of them properly at your nearest recycling centre.
Only dispose of batteries when they are flat.
M
The filter should be checked regularly and cleaned when
necessary.
1. Unscrew sleeve nut
from the tap thread (do not use pliers).
2. If necessary unscrew the adaptor
M
3. Remove filter from sleeve nut
4. Fit the Water Computer again (see 4. Putting Your Water
Computer into Operation "Connecting Water Computer" ).
0 : 30
again.
G
of the Water Computer by hand
H
.
G
and clean.