Maintenance - SPARKY PMW 1212CE Notice Originale

self - contact the nearest authorised SPARKY
service centre. Operating with a faulty machine
may cause an accident!
12. If no trouble is detected then you can start
operation.
REPLACING THE DIAMOND PARTICLE
PAD AND THE NONWOVEN fABRIC
(fIBRAT) PAD
1. Ensure that the power tool is unplugged
and the liquid feed system is not under pres-
sure.
2. Turn the machine in a way ensuring ac-
cess to the operating tool. We recommend fixing
the machine in stationary position. Thus it would
be possible to use both hands for convenient
and safe assembly.
3. Remove the operating tool you intend to
replace by tearing it from the flexible pad (10).
4. Follow steps 4 - 12 from section „Mount-
ing the diamond particle pad and the nonwoven
fabric (Fibrat) pad".
REMOVING DIAMOND PARTICLE PAD
AND THE NONWOVEN fABRIC (fI-
BRAT) PAD
1. Ensure that the power tool is unplugged
and the liquid feed system is not under pres-
sure.
2. Turn the machine in a way ensuring ac-
cess to the operating tool. We recommend fixing
the machine in stationary position. Thus it would
be possible to use both hands for convenient
and safe assembly.
3. Remove the operating tool (accessory)
which you intend to replace by tearing it from
the flexible pad (10).
RECOMMENDATIONS
When polishing and cleaning do not apply ex-
cessive pressure on the processed surface but
move the machine smoothly.
VII - Maintenance
WARNING: Always ensure that the
tool is switched off and unplugged before
attempting to perform inspection or mainte-
nance.
Original instructions
BRUSH REPLACEMENT
This power tool is equipped with auto-stop
brushes. When the carbon brushes are worn
out, the machine switches itself off. In this case
both brushes must be replaced simultaneously
with genuine brushes at SPARKY service centre
for warranty and post-warranty service.
GENERAL INSPECTION
Regularly inspect all fasteners and ensure they
are properly tightened. Should any of the screws
be loose, retighten it immediately to avoid haz-
ards.
If the replacement of the supply cord is neces-
sary, this has to be done by the manufacturer or
his agent in order to avoid a safety hazard.
CLEANING
For safe operation always keep the machine
and its ventilation slots clean.
Regularly check to see if any dust or foreign mat-
ter has entered the ventilation slots and the grills
around the switches. Use a soft brush and/or air
jet to remove any accumulated dust. Wear safety
glasses to protect your eyes whilst cleaning.
Exterior plastic parts may be cleaned with a
damp cloth and mild detergent if necessary.
WARNING: Never use alcohol, petrol
or other cleaning agent. Never use caustic
agents to clean plastic parts.
WARNING: Water must never come
into contact with the tool.
IMPORTANT! To assure product safety and re-
liability, repairs, maintenance and adjustment
(including brush inspection and replacement)
should be performed by certified service centres
or other qualified service organisations, always
using genuine replacement parts.
13
EN