Application; Start-Up And Shut-Down; Adjusting The Volume; Night" Mode - Focal SW 1000 BE Manuel D'utilisation

SW 1000 BE
U s e r m a n u a l
17

Application

Start-up and shut-down

Turn the power switch on the back of the unit to the "On" position. A "Loading" message will appear on
the display (this will only ever appear as start-up and shut-down of the subwoofer).
Thanks to the integrated "Auto-power" setting, start-up is automatic on receiving an audio signal on
the analog inputs. The message "FOCAL Electra 2" which appears on the screen indicates that the
subwoofer is operational and awaiting instruction. Start-up can also be attained (ex: setting parameters
of the subwoofer without an analog signal, see following chapter) by pressing the ➊ button on the
remote (fig. G).
In absence of an input audio signal, stand-by is as well automatic after approximately a period of 15
minutes. Stand-by can also be attained by pressing on the ➊ button on the remote.
When absent for several days, it is recommended to turn the power switch to "Off" on the back of the
amplifier.
During an electrical storm, disconnect the mains cable.

Adjusting the volume

Adjusting the volume (button ➋) allows a proper output level of the subwoofer compared to those of
the other speakers in the system. Establishing this by remote control permits a very precise fine-tuning
of the level according to the nature of the listening material.

"Night" mode

This type of digital, dynamic compression of the signal permits the user to avoid large differences in
playback level between weak and powerful signals. Weak signals are increased so that the bass is more
present and satisfactory, even at low listening levels, while powerful signals are decreased in amplitude.
This function allows for an excellent listening comfort in bass response, even at very low listening levels,
and to avoid disturbing the neighbors or others nearby.
The default message "FOCAL Electra 2" appears highlighted on the display when in "Night" mode
(button ➌).

Program application

Three digital memory settings are accessible on the remote control (button ➍). The factory settings
correspond generally to a range of applications. The "Hi-fi" mode corresponds to a setting, which is as
linear as possible, with a well-integrated and deep bass. "Cinema" is calibrated to be more demonstrative
and dynamic to highlight performance in film soundtracks. In the "User" mode, all corrections and filters
are deactivated. All these settings can be modified at will. Consult the table at the end of the manual to
return to the factory settings.