Dyna-Glo DGU951SDE Instructions page 24

TROUBLESHOOTING
.
PROBLEM
Flare-ups.
Persistent
grease fire.
Control Panel
Error Code
(E1, E2, E3 or E4).
POSSIBLE CAUSE
• Meat contains excessive
amounts of fat.
• Cooking temperature is
too high.
• Grease build-up.
• Too much build-up on
grease drip tray and/or
grease cup.
• Circuit failure in firebox temp
sensor or meat probe temp
sensor.
CORRECTIVE ACTION
• Trim the appropriate amount of fat
before cooking.
• Lower the temperature as needed.
• Clean the smoker, according to
the instructions.
• Turn off the smoker and carefully open the
upper door and carefully remove the
bottom drawer to allow the fire to burn out.
DO NOT use water to extinguish the
fire. Personal injury my result.
Allow the smoker to completely cool
before cleaning the tray and cup.
• Contact Dyna-Glo customer service for
parts repair or replacement options.
24