Assembly Instructions - Dyna-Glo DGU951SDE Instructions

ASSEMBLY INSTRUCTIONS

1. Remove the pre-installed screws on the bottom of
the cabinet assembly (A). Attach each of the rear
casters (B) to the bottom of the cabinet assembly
(A) using 4 M5 x 12 (CC) screws per caster. At-
tach the bottom of the front legs (C) to the bottom
of the cabinet assembly (A) using 3 M6 x 12 (BB)
screws per leg.
Hardware Used
M6 x 12 mm
BB
Screw
M5 x 12 mm
CC
Screw
2. CAUTION: This unit is HEAVY! Do not attempt
this step without assistance!
With the assistance of a helper, stand the smoker
upright on a firm and level surface. (Make sure
that legs and casters are firmly attached). Re-
move the pre-installed screws on the back of the
cabinet assembly (A) and attach the rear handle
(D) using the pre-installed screws.
Hardware Used
M5 x 12 mm
CC
Screw
v
1
x 6
x 8
2
x 4
10
BB
A
CC
B
C
BB
CC
D
A