Krups SOLO DIECAST XP601050 Mode D'emploi page 10

English
n Ensure that all parts are completely dry before re-assembling:
n Place the cup rest grill on the water drip tray and slide into the housing.
n Reposition the water tank by pushing it backwards towards the edge of the machine.
Filling the water tank
To fill the tank:
n Remove the water tank by pulling it forwards using the central handle (fig.1).
n Fill the tank with fresh water without exceeding the maximum water level.
n Return the tank into its housing by sliding it along the cup rest grill (fig.2).
n Ensure that you have pushed it right to the end.
Draining and priming of the water circuit
Before using the machine for the first time it is imperative that you allow the water to circulate through all
of the appliance's circuits to remove any possible air and for the pump to be activated.
With the water tank full:
n Connect the power cord
n Check that the rotating control button is set to PENDING (
SELECTION button (h2) is at
n Switch the machine on by turning the START/STOP button to the right to the (I) setting.
n The ON and TEMPERATURE lights
heating (approximately 1 minute).
NOTE
As long as the TEMPERATURE light
been reached.
n Place a sufficiently large enough container under the HOT WATER/STEAM spout.
n When the TEMPERATURE light
(fig.5).
n The pump starts working at a steady rate and the hot water flows through the spout. Proceed with
rinsing by circulating 1/4 of the full tank of fresh water through the spout.
n Stop the flow of water by simply returning the control button to PENDING (
n Empty the container and place it under the group head without using the filter holder.
n When the TEMPERATURE light
function and proceed with rinsing by circulating 3/4 of the tank through the group head. (fig.3).
n Stop the flow of water by simply returning the control button to PENDING (
n The water circuit has now been drained and your machine is ready for use.
NOTE
A little steam may be released from the water tank. This is completely normal.
12
.
come on straight away to indicate that the thermo block is
is on, the temperature
comes on, turn the rotating control button to HOT WATER
comes on, turn the rotating control button to the ESPRESSO
●
) and that the TEMPERATURE
has not
●
) (fig.6).
●
) (fig.4).