Philips SmartSleep Snoring Relief Band Mode D'emploi page 26

26
English
Problem
The reset does
not work.
Safety and compliance
Specifications
Adapter Philips WAA1001
Safety classification
Mode of operation
Ingress Protection marking
Input characteristics
No-load power consumption
Possible cause / solution
The long press was too short (<5 seconds).
Press and hold the activation button for five
seconds, until you see the countdown (3-2-1) on
the display and feel a vibration. Keep pressing even
when you see '- - 'on the display (after 2 seconds of
long pressing). The final vibration indicates that the
reset was successful. The adaptation phase is now
active again.
The sensor is off or the sensor is in a sleep session
'- -'. The long press (five seconds) only works when
the display is active and shows one of the sensor
data screens (see 'Sensor data').
The Snoring Relief Band meets the safety
requirements in the EU for:
- IEC 60335: Household and similar electrical
appliances
IEC 62368: Audio/video, information and
communication technology equipment
- IEC 62133: Batteries
- IEC 61558: Adapters
Class II power supply (double
insulation)
Continuous
IPX4 (protection against splashing
water)
100-240 Vac, 50/60 Hz, 3.5 W
0.03 W