RIB J-INV 3P Mode D'emploi page 33

13. TIPS FOR A SUCCESSFUL INSTALLATION
13.1 High speed movements
PROBLEM
•
The motor stops for the effort during the movements
•
It is easy to stop the automation during the movements counteracting the movement
•
The door moves slowly despite having set an high speed
•
The motor stops and the control board shows FAULT on the display or 10 seconds of fast
blinking
13.2 Low speed movements (slowing down)
PROBLEM
•
The motor stops for the effort during the movements
•
It is easy to stop the automation during the movements counteracting the movement
•
The door moves slowly despite having set an high speed
Power supply
Photocells power supply
Accessories power supply
Motor output
Flashing light output
Courtesy light output
Electrobrake or electric lock output
Clean contact output NOT supplied.
TECHNICAL FEATURES
230 Vac ±15% 50/60Hz 1-phase
24 Vdc 3W MAX
24 Vac 3W MAX
230 Vac 3-phase 1,5KW (current limited to 10A) MAX cosφ > 0.8
230 Vac 60W MAX for fixed light, without self-blinking.
230 Vac 100W MAX
230 Vac 5A Max, 30 Vdc 5A Max
33
•
Raise the torque supplied to the motor until problem is solved
High Torque OP, High Torque CL
•
Lower the speed of the motor until problem is solved
High Speed OP, High Speed CL
•
Lower the torque supplied to the motor until problem is solved
High Torque OP, High Torque CL
•
Lower the speed of the motor until problem is solved
High Speed OP, High Speed CL
•
Raise the torque supplied to the motor until problem is solved
Low Torque OP, Low Torque CL
•
Lower the speed of the motor until problem is solved
Low Speed OP, Low Speed CL
SOLUTION
SOLUTION
G
B