Troubleshooting; Advice - Amici IPERESPRESSO X2.1 Manuel D'instructions

TROUBLESHOOTING

PROBLEM SOLUTION
The brewing light (F) or (H) Carry out the following steps:
blinks very quickly.
-
-
-
If the light continues blinking quickly repeat the previous operation twice.
It is always possible to continue using the operating groups (brewing and steam group) of the ma-
chine.
The steam light (G) blinks very Carry out the following steps:
quickly.
-
-
-
-
-
It is always possible to continue using the brewing groups of the machine.
The machine stops brewing There is no water in the tank:
coffee.
-
-
-
It is always possible to continue using the operating brewing groups of the machine.
I move the switch (C) down- Check that:
wards and the machine does
-
not dispense steam
-
-
Water comes out of the ma- -
chine.
-
Water comes out of the group -
during brewing.
-
I switch on the machine but Check the condition of protection switches of the power supply. Check that the power cord is con-
the light (E) does not turn on. nected to the machine. Plug the power cord to the power supply.
The light (F/G/H) does not turn
on any more and the group It is always possible to continue using the operating brewing groups of the machine.
does not work.

ADVICE

In order to obtain an high-quality espresso, remember to:
- heat the cups before use (on the cup warming surface or using hot water)
- brew espresso only when the lights (F and H) are on
- dispense a small amount of water before and after using the machine in order to maintain the machine in the best operating conditions
- switch on the machine at least 20 minutes before use
- change the water in the tank at least twice a week.
It is also recommended to use water with low calcium content in order to reduce limescale within the machine.
switch off the machine;
fi ll in the tank if necessary;
switch on the machine and wait until the BLUE light (F or H) turns on.
switch off the machine;
fi ll in the tank if necessary;
switch on the machine and wait until all the lights turn on
place a container under the steam wand and move the steam switch (C) downwards;
Move again the switch (C) downwards;
fi ll in the water tank;
remove the capsule holder from the group;
activate a brewing switch of your choice until water comes out.
the tank contains water;
the light (G) is on;
dispense steam.
switch off the machine;
unplug the machine.
Check that the fi lter and capsule holder is inserted correctly.
Try again using a new capsule.
27
ENGLISH
IF PROBLEM
PERSISTS
Contact
the service center