Technical Characteristics; Warranty Limitations - Amici IPERESPRESSO X2.1 Manuel D'instructions

ENGLISH
FINAL RINSING PHASE
At the end of the descaling cycles of the steam and brewing groups, empty the tank, wash it carefully under running water and fi ll it again with fresh water.
1 Litre
1 Litre
2 Litre
At the end of the rinsing cycle empty the containers. The machine goes back to the normal operation mode.
WARNING:
• Do not drink the solution dispensed during the descaling process. The machine can be used to brew coffee only when the descaling process has been
completed. It is recommended to use the specifi c product for descaling. If the descaling procedures are not carried out, the limescale can clog the
hydraulic circuit. This may cause poor machine performance or failure.
• Should an electrical blackout occur, when the power supply has been restored the steam light (G) blinks quickly every 5 seconds for 10 times. This
indicates that the descaling/washing cycle needs to be completed. Press the same steam switch (C) again upwards to restart the cycle.

TECHNICAL CHARACTERISTICS

Body: stainless steel
3 independent thermoblocks (aluminium and stainless steel)
3 pumps with rated pressure of 15 bar (1.5 Mpa)
Voltage: 230 V, 50 Hz (EU)
Power: 2400 W (EU)
Tank: 5 litres
Weight: 22 kg
Dimensions: 46 cm wide x 39 cm high x 36 cm deep
A-weighted sound pressure level 72 dB, uncertainty 2.5 dB.
Drip tray capacity: 1 litre (about 100 brewing cycle).
Electronic temperature control.
Steam dispensing.
Heated top that functions as cup warmer to keep the cups at the perfect temperature.
The user can program different brewing volumes (2 for each group).
The manufacturer reserves the right to undertake modifi cations or improvements without notice.

WARRANTY LIMITATIONS

The guarantee does not cover:
1. damage caused by failure to descale the appliance or to perform ordinary maintenance as set out in the present manual
2. damage caused by improper use or installation not in compliance with the instructions of the manufacturer provided in this manual
3. defects in the casing or in the appearance deriving from use of the machine (scratches, dents, etc.)
4. damage caused during shipping if undertaken in non-original packing
5. defects related to the beverage when not caused directly by the operation of the machine.
The guarantee becomes void:
1. in the case of non-original spare parts being used
2. in the case of technical assistance or service centre not authorised by the manufacturer being used.
Place a container under the steam wand (O), with a capacity of at least 2 litres.
Place a container with a capacity of at least 1 litre under each group (L-T).
To start the rinsing cycle move the steam switch (C) upwards for less than 2 seconds. All lights start blinking quickly. During
the rinsing cycle water is dispensed automatically at pre-set regular intervals.
26