Safety Notes; Important Notes; Functions; Spare Parts - LGB 25554 Mode D'emploi

Safety Notes

• This locomotive is to be used with the operating system
designed for it.
• Use only switched mode power supply units and transfor-
mers that are designed for your local power system.
• This model may only be supplied with power from a
suitable power generation source.
• Pay close attention to the safety notes in the instructions
for your operating system.
• Not for children under the age of 15.
• WARNING! Sharp edges and points required for operation.

Important Notes

• The operating instructions are a component part of the
product and must therefore be kept in a safe place as
well as included with the product, if the latter is given to
someone else.
• Please see your authorized LGB dealer for repairs or

spare parts.

• http://www.maerklin.com/en/imprint.html
• The warranty card included with this product specifies
the warranty conditions.

Functions

• This model is designed for operation on LGB two-rail DC
systems with conventional LGB DC train controllers or
power packs (DC, 0 - 24 volts).
• This model comes from the factory with a built-in multi-
train system decoder (multi-train system).
• For operation with the Multi-Train System, the model is
programmed to loco address 03.
Note: Use a locomotive controller with more than 1 amp of
8
train current for this model.
Mode of Operation Switch
There is a 4-position mode of operation switch in the loco-
motive (Fig. 1).
Pos. 0 All power off
Pos. 1 Power to lights
Pos. 2 Power to motors and lights
Pos. 3 Power to motors, lights and sound
Multi-Purpose Socket
The model has a "flat" multi-purpose socket, with a remo-
vable cover, at the rear of the loco (Fig. 2). These sockets
can be used to provide track power to cars with lighting or
sound electronics.
Multi-Train System
The model is equipped with a factory-installed onboard de-
coder for the LGB Multi-Train System. It can be used without
modifications on analog or digital layouts.
When operating with the Multi-Train System, the loco
features a "Back-EMF" function. This keeps the motor
speed constant, even when the load of the loco changes, for
example, in curves or on grades. This feature does not work
at top speed.
Sound
This model features a digital electronic sound system. The
volume control is located under the radiator housing behind
the cab (Fig. 1). The bell and whistle also can be triggered
using the LGB Sound Trigger Magnet (17050) included with
this model. The 17050 snaps between the ties of most LGB
track sections.