Publicité
Les langues disponibles
Les langues disponibles
5. Powerfilter PF 1000
5.1
Features
The inside aquarium filter PF 1000 is watertight and safe against flooding. It works in a very quiet way.
The synchronous motor is fully encased. All materials are sea water resistant.
The ceramic shaft is nearly wear-resistant so that a long life span is guaranteed. The whole pump can be
disassembled for cleaning. Each electrical part is encapsulated. The filter can be used in aquariums up to
100 l as filter or as current pump in larger aquariums.
5.2
Technical Data
Power Filter PF 1000
Line voltage:
Power consumption:
Maximum litre/hour:
Pump height (max):
Length of cable:
Protection:
Maximum submergance:
Max. water temperature:
5.3
Parts of the pump
1. Motor housing
2. Pump head
3. Air injection nozzle
4. Filter basket
5. Filter sponge
6. Lid for filter basket
7. Holding plate
8. Rubber sucker
9. Rotor / magnet and
impeller
10. Ceramic shaft
11. Rubber bearing
12. Power cable
5.4
Mounting:
The filter is designed for underwater use only. The max. submergance is 1 m. In any case, dry running of
the pump has to be avoided.
The holding plate (7) with the rubber suckers (8) can be connected with the pump from 2 sides. The
pump head (2) can be fitted to the motor (1) in 2 ways, so the outlet can be adjusted. A further
possibility to direct the water flow is using the 45° elbow. If aeration is desired, the air injection nozzle
can be mounted.
Security advise:
The pump is constructed for indoor use only. Before working on the aquarium or
pump, always disconnect the device from the mains. The connection cable and the
power plug may not be changed. If the power cable is damaged, the pump may not be
used any more. After setting up the pump, make sure you can always reach the power
plug.
230 V/50 Hz
10 W
1,000 (16)
1.0 m
1.5 m
IP68
1 m
35°C
23
Publicité
