Cub Cadet 19A40039100 Notice D'utilisation page 5

7. Assemble a washer, a spacer, a washer, and a wheel
onto the end of the axle. See figure 4.
8. Install a 1/4" x 1" hex bolt into the hole in the end of the
axle. See figure 4.
1/4 x 2
HEX BOLT
1/4
NYLOCK
NUT
WASHER
FIGURE 4
9. Turn the spreader upright on its wheels.
10. Insert the pinched end of the flow control rod through
the hole in the in the flow control arm. See figure 5.
FIGURE 5
ENGLISH
WHEEL
SPACER
FLOW
CONTROL
ROD
11. Insert the hook end of the flow control rod through the
hole in the slide gate bracket located under the hopper.
See figure 6.
FIGURE 6
12. Assemble the flow control mounting tube to the hitch
tube using two 5/16" x 1-3/4" hex bolts and 5/16" nylock
hex nuts. DO NOT TIGHTEN YET. See figure 7.
5/16 x 1-3/4
HEX BOLT
FIGURE 7
5
5/16 NYLOCK NUT