4.1.2 The tap
It is most advisable to give the tap an extra cleaning at regular intervals. The level gauge brush
which is supplied with the appliance can be used for this purpose.
To clean the tap, follow the instructions given below:
1. Loosen the cap with locking mechanism and remove it.
2. Remove the plug at the front of the tap.
ATTENTION
► Keep in mind that any (hot) water remaining in the reservoir will spurt straight out when the
plug is removed.
3. The connecting pipe to the reservoir, as well as the tap housing itself, can now be
thoroughly cleaned on the inside with the special brush. Use a good cleansing agent for
this purpose.
ATTENTION
► Also remove any deposits from the threads and the cap.
4. Once they have been cleaned and all incrustation has been removed, the pipe and the tap
housing should be thoroughly rinsed with ample hot water. Don't forget to rinse the cap
and plug threads properly as well.
5. The inside of the plug and of the cap with locking mechanism should now be thoroughly
cleaned as well, after which they should be rinsed with ample hot water.
ATTENTION
► Make sure that no traces of cleansing agent remain in the locking mechanism.
6. After cleaning and rinsing, put the cap with locking mechanism and the plug back on the
tap.
4.1.3 The outside
The outside of the appliance can easily be cleaned with a damp cloth. Use a cleanser if
necessary, but it is most inadvisable to use scouring pads or abrasives, which inevitably leave
scratches on the appliance. Aside from thorough cleaning of the appliance and all accessories
after each use, the milk heater requires no maintenance.
Should you have questions or complaints, please contact your dealer.
EN
5