An Overview Of The 191Xl Series - Federal Signal Beacon 191XL Serie Manuel D'installation Et D'entretien

Installation and Service Instructions
• After installation, test the beacon to make sure that it is
operating properly.
• Keep the unit tightly closed when in operation.
• After testing is complete; provide a copy of this instruction
booklet to all personnel.
• Establish a procedure to routinely check the beacon for proper
activation and operation.
Failure to follow all safety precautions and instructions may result
in property damage, serious injury, or death.

An Overview of the 191XL Series

The 191XL is suitable for use in Class I, Division 2, Groups A, B,
C and D; Class II, Division 1, Groups E, F & G; Class III OR non-
hazardous locations only.
The 191XL-CN is suitable for use in Class I, Zone 2, and Zone 22
or non-hazardous locations only.
This strobe light can be mounted to a Federal Signal Model
LHWB bracket. If installed in this way, the entire assembled
device is suitable only for Class I, Div. 2, Groups A, B, C, and D;
Class II, Div. 2, Groups F and G; Class III locations.
The Model 191XL Series LED Beacon is a UL listed visual signal
for operation in harsh environments and hazardous locations
and has been investigated by UL as meeting Type 4X and IP66
enclosure requirements. The unit is rated for operation on 100 Vac
to 265 Vac, 50/60 Hz, 0.21 A; 277 Vac, 50/60 Hz, 0.13A; or 24
Vdc/ac 50/60 Hz, 0.40 A. The 191XL Series can be supplied with
colors of red, amber, green, blue, and clear. The 191XL Series
is factory-set to operate 60 flashes/minute. There is an option to
operate the LED Beacon in Steady Mode. (See "Changing from
Flash Mode to Steady Mode" on page 14). Models are available
for pipe mounting (191XL Series) or surface mounting (191XL-S
Series).
6
Model 191XL Series LED Beacon