Publicité
Les langues disponibles
Les langues disponibles
PREPARATION
Assembly (ref. Fig. 1)
1. Make sure all parts are present. If any part is missing
or damaged, do not attempt to assemble or operate
the product. Contact Omega Customer service (888)
332-6419.
2. Insert extension tube to the base.
Before Use
1. Read this manual completely and familiarize yourself
thoroughly with the product and the hazards
associated with its improper use before using the
product.
2. Verify that the product and the application are
compatible, if in doubt call
(888) 332-6419.
3. Inspect jack stands before each use. Do not use if
there are bent, broken or cracked components noted
(including labels). Ensure that all parts move freely.
4. Consult the vehicle owners or service manual for location of proper lift and support points.
OPERATION
!
WARNING: Support areas of vehicle specified by vehicle manufacturer. Use ONLY on vehicles whose support
points are compatible with saddle of jack stand. Incompatibility may result in structural damage to vehicle and/
or jack stand.
1. Adjust saddle height by pulling up the extension tube, then insert the tube support bar through the hole on
extension tube.
2. Check to ensure support bar is secured and nested across two corresponding radii before loading. Ensure that
support bar is inserted completely so that bar stop engages the collar.
3. Carefully position jack stands so that load is centered on stand's saddle.
4. Slowly lower the vehicle onto the stands. Once loaded, ensure base of jack stands is firmly planted on ground.
5. Check to ensure vehicle is secured before working on, around or under. Use wheel chocks on all unlifted wheels
in both directions to prevent inadvertent movement.
To lower load
!
WARNING: Clear all tools and personnel before lowering load.
1. With suitable jack, raise vehicle clear of stands.
2. Carefully remove stands, then carefully lower vehicle with lift device.
MAINTENANCE
Periodically inspect each stand. Ensure all parts move freely. Do not apply oil or grease to any portion of this product.
If rust appears, sand affected area and cover with suitable utility paint.
Storage
Store stands in upright position and in a clean, dry area.
Omega Customer Service
!
WARNING
• Study, understand, and follow all instructions
before operating this device.
• Do not exceed rated capacity.
• Use only on hard, level surface.
• Center load on saddle.
• Use as a matched pair only.
• Stands are not to be used to simultaneously
support both ends of a vehicle.
• No alteration shall be made to this device.
• Failure to heed these markings may result in
personal injury and/or property damage.
3
Publicité
