Publicité
Les langues disponibles
Les langues disponibles
8558785
OPERATION
ADJUSTING THE EXHAUST
The adjustable exhaust on the cap of the tool allows users to direct
the exhaust according to operator preference. To adjust the direction,
turn the exhaust cap in the desired direction.
LoADING FASTENERS
1.
Connect the tool to the air source.
2.
Pull the pusher (B) back until the fasteners follower falls
behind the fasteners. Insert the strip of fasteners into the
rear of the magazine (C). Be sure
the fasteners are pointed downward.
3.
Pull the pusher to let it go back to
move the fasteners up to the driving
mechanism. The pusher will stop
when it rests against the end of
the fastener.
WARNING: The tool may fire when it is first
connected to the air resource.
Always connect the tool to the air resource
before loading fasteners to prevent injury
from unintended cycling. Always make
sure the tool's magazine is empty at the
beginning of each work session, before
connecting to an air resource.
WARNING: Use only those fasteners
recommended for use with this tool.
Fasteners not identified for use with this tool by the tool manufacturer are able to result in a
risk of injury to persons or tool damage when used in this tool.
WARNING: Keep the tool pointed away from yourself and others when loading fasteners.
Failure to do so could result in possible serious personal injury.
WARNING: Never load fasteners with the workpiece contact or trigger activated. Doing so
could result in possible serious personal injury.
UNLoADING FASTENERS
Unloading is the reverse of loading, except always disconnect the air source before unloading.
WARNING: Always unload all fasteners before removing tool from service.
WARNING: Always disconnect the air resource before unloading.
Visit www.princessauto.com for more information
16 Gauge Straight Finish Nailer
Pusher (B)
Rear of magazine (C)
V 4.0
9
Publicité
