Publicité
Les langues disponibles
Les langues disponibles
8558785
DEPTH ADJUSTMENT
The driving depth of the fasteners are
adjustable. To adjust the depth, use the drive
depth adjustment wheel (F) on the right side of
the tool.
1.
Disconnect the tool from air source.
2.
Turn the depth wheel left or right to
change the driving depth.
3.
Reconnect the tool to the air source.
4.
Drive a test nail after each adjustment
until the desired depth is set.
CAUTION: It is advisable to test the depth on
a scrap workpiece to determine the required depth for the application. To determine depth of
drive, first adjust the air pressure and drive a test fastener. Never exceed 120 psi.
FIRING THE TooL
SINGLE SEQUENTIAL FIRING MODE
The tool is specially designed for single sequential mode. This mode requires the trigger to be
pulled each time a fastener is driven. The tool can be actuated by depressing the work contact
element against the work surface followed by pulling the trigger.
The trigger must be released to reset the tool before another fastener can be driven.
WARNING: During normal use the tool will recoil immediately after driving a fastener. This
is a normal function of the tool. Do not attempt to prevent the recoil by holding the tool
against the work. Restriction to the recoil can result in a second fastener being driven from
the tool. Grip the handle firmly and let the tool do the work. Failure to heed this warning can
result in serious personal injury.
MAINTENANCE
WARNING: Any time inspection, maintenance, and cleaning are done:
•
Disconnect the tool from the air resource.
•
Empty the magazine completely.
ANTI-DUST
Each tool is packed with an anti-dust cap on the air connector, check it after unpacking.
Keep the anti-dust cap cover the air connector when the tool is not in use.
LUBRICATIoN
Frequent, but not excessive, lubrication is required for best performance after long periods of
use. Oil for pneumatic fastening tools is added through the air line connection and will lubricate
internal parts. Do not use detergent oil or additives. These lubricants will cause accelerated
wear to the seals and bumpers in the tool, resulting in poor tool performance and frequent
tool maintenance.
CAUTION: Lubricate tool only with specified lubricants.
Visit www.princessauto.com for more information
16 Gauge Straight Finish Nailer
Adjustement wheel (F)
V 4.0
11
Publicité
