Power Fist 8558785 Manuel D'utilisation page 13

8558785
TROUBLESHOOTING
WARNING: Stop using tool immediately if any of the following problems occur. Serious
personal injury could result. Any repairs or replacements must be done by a qualified
service person or an authorized service center.
PRoBLEMS
Air leaking near the
top of the tool or in
the trigger area.
Air leaking near the
bottom of the tool.
Tool does nothing or
operates sluggishly.
Fasterners are jammed
in the tool frequently.
WARNING: Use only identical replacement parts. For questions please call 1-800-665-8685
or visit our website at www.princessauto.com.
WEARING PARTS
Repair parts can be ordered from our website: www.princessauto.com or by calling
1-800-665-8685.
Visit www.princessauto.com for more information
16 Gauge Straight Finish Nailer
PoSSIBLE CAUSE(S)
1. Loose screw.
2. Worn or damaged O-rings
or seals.
1. Loose screws.
2. Worn or damaged O-rings
or seals.
1. Inadequate air supply.
2. Tool is too dry.
3. Exhaust blocked.
4. Worn or damaged O-rings
or seals.
1. Drive channel is worn.
2. Piston is broken or worn.
3. Bent fasteners.
4. Dirty magazine.
5. Loose magazine.
6. Wrong fasteners.
CoRRECTIVE ACTIoN
1. Tighten screws.
2. Install overhaul kit.
1. Tighten screws.
2. Install overhaul kit.
1. Make sure the air compressor
is set between 70 and 110 psi.
2. Add about 2 to 3 drops
of lubrication into the
air connector.
3. Clean exhaust channel.
4. Install overhaul kit.
1. Fix the drive channel.
2. Replace the piston.
3. Remove the bent fasteners,
replace with the right fasteners.
4. Clean magazine.
5. Tighten screws.
6. Verify that fasteners are the
correct size.
V 4.0
13