Power Fist 8558785 Manuel D'utilisation page 10

V 4.0
CLEARING JAMS
Occasionally, a fastener may become jammed
in the firing mechanism of the tool, making the
tool inoperable. To remove a jammed fastener,
follow the steps below:
1. Disconnect the tool from air source.
2. Remove fasteners from the tool.
Failure to do so will cause the
fasteners to eject from the front of
the tool.
3. Pull up on the latch (D) and open the
jam release (E).
4. Using caution not to bend or
damage the driver blade, using
pliers or a screwdriver if required to
clear the jammed fastener.
5. Close the jam release and latch.
6. Reconnect the tool to the air source.
7. Reload the tool with fasteners.
WARNING: Make sure there is no fastener in magazine before clearing a jam.
WARNING: Disconnect the tool from the air source whenever clearing a jam. After
disconnecting the tool from the air compressor, there should still be enough air pressure
to fire the tool. After the air hose is disconnected, always fire the tool into scrap wood
repeatedly to make sure all of the compressed air is expended.
NoN-MARRING PAD
The non-marring pad attached the nose of the tool helps prevent marring and denting when
working with softer woods.
WARNING: Disconnect the tool from the air source before removing or replacing the no-
marring pad. Failure to do so could result in serious personal injury.
SETTING THE AIR PRESSURE
The amount of air pressure required depends on the size of the fasteners and the workpiece
material. Begin testing the depth of drive by driving a test nail into the same type of workpiece
material used for the actual job.
Drive a test fastener with the air pressure set at 90 to 95 psi. Raise or lower the air pressure to
find the lowest setting that will perform the job with consistent results.
It may be possible to achieve the desired depth with air pressure adjustments alone.
10
16 Gauge Straight Finish Nailer
Latch (D)
Jam release (E)
For technical questions call 1-800-665-8685
8558785