Siemens Synco 700 Manuel D'utilisation page 41

Entering additional switching points
1. Select the required day.
2. In the diagram, advance pointer
in time of the current program.
3. Turn the OK knob by one notch;
––:–– –––––– appears.
4. Set the required start time.
5. Select the required room operating mode.
Copying a 24-hour heating / cooling program
1. Select the day to be copied.
2. Turn the OK knob in clockwise direction until Copy to:
appears.
3. Press the OK knob.
4. The menu with the selection of days (week section,
individual weekdays, special day) appears.
5. Select the required weekday or week section.
6. Copy (press the OK knob).
First, prepare a 7-day schedule for the daily switching times and operating modes – this will facilitate entry into the
Siemens Building Technologies / HVAC Products
to the last point
controller!
CE1B3144x2
New 24-hour program
The controller is supplied with a 24-hour program for
every day (including the special day). This means that
you will never have to create a new 24-hour program,
but only change an existing program.
Operating voltage off – heating / cooling program
lost?
In the event of a power failure, the 24-hour programs
entered will be maintained, independent of the duration
of the power failure.
74 319 0350 0
17
16.05.2003