Start-Up And Operation; Infrared Control - S&P EMIBLUE-DP Manuel D'installation & D'utilisation

c) Hour: See and/or modify the time. This option enables the user to view
the time programmed in the transmitter using the remote control, or adjust
it directly. On accessing this option, the minutes are displayed flashing.
Adjust the minutes with the "StandBy" key, and set the value with the
Manual key, then the hours will begin to flash and can be adjusted with the
"StandBy" key. Pressing the Manual key will display the day of the week
selected (1=Monday, 2=Tuesday,). Finally, and as additional information,
once the day of the week has been established, the automatic program-
me that the transmitter has activated will be displayed, which is the one
that will enter into operation when the "Auto" function is selected with the
remote control.
d) Reset. This function resets the appliance, erasing the parameters modi-
fied by the user and loading the default values. To reset the equipment,
press the StandBy key for 5 seconds

5. START-UP AND OPERATION.

1. - Press the "StandBy" key until the associated LED_goes out. The dis-
play will be illuminated.
2. - Press the Manual / Temperature key until you have the selected
ambient temperature.
3.- When the room has reached the desired temperature, the appliance
will switch on and off automatically, maintaining the selected ambient
temperature constant.
4. - To stop the appliance, press the "StandBy" key (Status LED_red).
Note: If there is any disturbance, the overheating disconnection system
will automatically disconnect the appliance and it will stop heating. To
reset it, follow these instructions:
- Stop the appliance by pressing the StandBy key (Status LED_red).
- Disconnect the equipment from the mains
- Let the appliance cool for about 30 minutes.
- Make sure that there is no obstruction to free air flow.
- Press the StandBy key again (status LED green or amber).
- If, after these actions, the appliance does not work normally, please con-
tact the wide S&P Official Technical service network.

6. INFRARED CONTROL

The appliance features an infrared receiver allowing it to receive, via a
remote control unit (optional), permanent programming to enable the
appliance to work independently. Programming and transmission instruc-
18