S&P EMIBLUE-DP Manuel D'installation & D'utilisation page 17

4. - Manual / Temperature key.
This key is used to manually select the desired ambient temperature, or if
you have a remote control, to select a different temperature to that pro-
grammed using the remote control.
By pressing the key successively, you can select a temperature according
to the following list:
0>1>2>3>4>5>6>7>8>9>10>11>12>13>14>15>16>17>17,5>18>18,5>19>19,5>20>20,5
For example, if you start from a set temperature of 21.5 ºC and want to go
down to 20ºC, press the Manual key successively until you reach 30ºC and
then start again at 0ºC until you reach 20ºC.
Observe that in the most common temperature range, from 17 to 23ºC the
selection is not degree by degree, but in 0.5ºC steps for more precise
adjustment.
Note that in normal functioning status, the transmitter displays the real
ambient temperature of the room on screen. The first time you press will
not modify the temperature selected; it will just display the temperature.
Successive presses will modify the chosen temperature, as described
above.
If at any time you wish to return to automatic mode (only if you have pur-
chased the MP-EMIBLUE remote control, offered as an accessory), you
can select this mode in the remote control itself.
- Keyboard locking function:
To avoid unwanted manipulation by third parties, pressing the StandBy key
for 10 seconds will block access to the equipment through the panel keys.
To unlock the keys, just press this key for 10 seconds. In both cases the
locking / unlocking is confirmed on screen. (Loc / ULoc)
- Configuration function:
By pressing the Manual key for 10 seconds, you access the configuration
menu ("CONF" displayed on screen), where you can adjust the following
parameters:
a) Select the temperature unit (ºC or ºF). Pressing the "StandBy" key, you
can access the option and select the desired unit. Press the Manual key to
validate the selection.
b) LCD. Use this option to choose between two operating modes for scre-
en illumination:
i) Screen only illuminated during adjustments (Mode 0)
ii) Screen always illuminated (Mode 1).
One or the other mode is selected by pressing the "StandBy" key, confir-
ming the selection with the Manual key.
>21>21,5>22>22,5>23>24>25>26>27>28>29>30
17