Start-Up And Operation - S&P SAHARA 1002 Manuel D'installation

- If the radiator is covered, there is a risk of overheating.
- If the power cable is damaged, it must be replaced with a cable sup-
plied by S&P or the after sales service.
- When disposing of the appliance always adhere to the corresponding
provisions for the elimination of the internal oil.
- This appliance is not intended for use by persons, including children,
with reduced physical, sensory or mental capabilities, or lack of expe-
rience and knowledge, unless they have been given supervision or ins-
truction concerning use of the appliance by a person responsible for
their safety.
- Children must be under watch to avoid that they could play with the
product.
ASSEMBLY
For transport reasons, the wheels are not fitted and are supplied
separately within the packaging.
1.- Remove the wheel set from the packaging.
2.- Turn the radiator over with care and rest it on a rug or other soft
surface to prevent damage.
3.- Insert the fixing ring in the hole on the base of the wheel set (Fig.1).
4.- Position the base of the wheel set underneath the radiator, which can be
lifted using the handle. Once correctly in place, position the ring in the other
hole in the base.
5.- Fix the ring onto the wheel set base using the wing nut (Fig.2).
6.- Check that the wheels are correctly fitted.

START-UP AND OPERATION

1.- Before connecting the device to the mains, check that the grid voltage
coincides with that shown on the data plate.
2.- The red pilot light indicates that the radiator is correctly connected to the
mains. This does not mean that the radiator is heating.
3.- Select the required power using the rotating switch (Fig.3).
8