Maintenance And Cleaning - S&P TERMOTECH-TS200/03 Manuel D'installation

INSTALLATION OF RADIANT PANEL CONTROL APPARATUS
The installation of the TERMOTECH-TS Kit CE switchboard MUST be carried out in
accordance with the manual.

MAINTENANCE AND CLEANING

Disconnect the power supply when cleaning. Do not use benzene, solvents, corrosive
additives or any similar products when cleaning the radiant panel.
Cable replacement must be carried out in accordance with the instructions in the
'Installation and electric wiring' section of the manual.
Symbols used in this manual:
DANGER Indicates a situation that may result in serious accidents or even death.
CAUTION - indicates a situation that, directly or indirectly, could cause personal harm or material or environmental damage.
WARNING - pay special attention to the instructions.
WITHDRAWAL FROM SERVICE AND RECYCLING
When no longer in use, even for a short period, it is advisable to store the appliance in a dry,
dust free place.
Help us protect the environment by eliminating the packaging in agreement with the national
legislation in force on waste disposal.
Do not discard appliances bearing this label with non-classified waste. They must be
collected and discarded in the required way.
Old appliances must also be scrapped in an appropriate fashion, in agreement with the local
regulations and by-laws.
THE MANUFACTURER WILL NOT BE RESPONSIBLE FOR ANY DAMAGE PRODUCED DUE
TO NON-COMPLIANCE OF THESE WARNINGS .
11